Word Count:
345
For the best Loft Conversion And Garage Conversion company, call DPC Construction Cork.
Thinking of building an infrared home sauna? Make sure your new sauna uses 100% ceramic emitters built into the wall of the sauna room for safety and energy efficiency.
ceramic infrared sauna, infrared saunas, home saunas, saunas
To find the best Loft Conversion And Garage Conversion company, click here for DPC Construction Cork.
A ceramic infrared sauna harnesses the beneficial rays of the infra-red light spectrum to heal and detoxify the body. Infrared heat is similar to the heat from the sun minus the suns harmful effects on the skin. The technology has been used in hospitals to warm newborn babies and is completely safe to use, even for prolonged periods of time. Infra-red heat warms the body directly through a process called conversion instead of heating the air inside the sauna. The ceramic emitters that come with these far infrared sauna kits are very energy efficient and inexpensive to operate.
Infrared Heater Placement
The best infrared saunas use 100% ceramic emitters built into the wall of the sauna room. A 4′ x 4′ room requires a kit with at least four to five emitters. Place the emitters all around the four walls to receive the maximum benefits from all directions. A 4-person sauna might require a kit with six far infrared ceramic elements. Install three elements above the bench to warm the backs of the sauna bathers, one emitter below the bench to warm the legs and two in front at chest height.
Installation Precautions
Improper installation of a far infrared kit can cause a fire hazard. Ceramic emitters for use in home saunas are UL and CE certified but once installed the sauna itself is not UL approved. A licensed electrician should be hired to install and wire the infra-red heating elements according to local building codes.
Energy Efficiency and Life of Ceramic Infra-Red Heaters
With an estimated 10,000 operational hours per element, far infrared home sauna kits will provide a lifetime of sauna enjoyment. If you consider that a 4 x 4 x 6 room requires a 3 KW electric heater which can be replaced by five 200 W infrared elements for a total of 1 KW in energy usage, it makes sense to go with these kits. The housing, reflector and heat shield of these ceramic emitters are available in stainless steel or galvanized metal and the emitters are convertible to plug into 110V or 220V systems.
