Word Count:
279
For the best construction project management consultancy company, call EK Consultants.
Before laying the bathroom tiles, start by removing your old carpet and carpet strips. Use a cutoff saw to make room for the bathroom tile to slip under the doorjambs.
Bathroom tiles, bathroom tiles
To find the best construction project management consultancy company, click here for EK Consultants.
Laying your bathroom tiles with a dynamic flooring pattern or a deep wall color can make the difference as you remodel your bathroom floor. A nice bathroom needs a ceramic tile floor.
Before laying the bathroom tiles, start by removing your old carpet and carpet strips. Use a cutoff saw to make room for the bathroom tile to slip under the doorjambs. Place a portion of the tile pattern starting at the doorway to set up a centerline and then strike a chalk line.
Cut the bathroom tile with a wet saw or tile snips. Work your way up one side of the room and down the other. Allow 1/8″ for grout lines; spacers can be used for consistency. Mix the thinnest using an electric drill with a mixing bit.
Mix small amounts at a time, adding water slowly to maintain the right consistency. Mix enough to lay down a dozen or so bathroom tile at once, and be ready to go to work as the thinnest dries quickly using a trowel to apply the thinnest to the floor.
When the bathroom tiles are all in place and some-what dry, use a grout saw to scrape the excess thinnest out of the joints where the grout will go. A shop van will clean most of this up, but use a wet sponge to get the surface clean. Once dry, begin applying the grout with a rubber trowel.
One more sponge cleaning will be required to get up the film once the bathroom tiles is dried completely. It’s recommended to apply a grout sealer after about 48 hours or so to help avoid any staining problems that occur during normal use.
